MIL-STD-867 Temper Etch InspectionThis standard establishes requirements and test for performing temper etch inspection of carburized steels and tool and low alloy steels, which are heat treated above 1.24 x 109 Pascal PA 1.26 x 102 kilogram - force/square millimeter Kgf/mm2 or 1.8 x 105 pound - force/square inch psi. This standard applies to aircraft and missiles structural and propulsion system components when MIL-HDBK-6870 for guidance only and/or MIL-STD-866 are reference documents in the solicitation or contract.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16

FOREWORD

1.  This military standard is approved for use by 309MXSG/MXRL, Department of the Air Force, and is available for use by all departments and agencies of the Department of Defense.

2.  This standard provides guidance on the processes for the grinding of chrome plated steel and steel parts for the Air Force repair, acquisition, and manufacture of parts and/or spare parts on the landing gear of all military aircraft.

3.  Beneficial comments, recommendations, additions, deletions, and any pertinent data, which may be of use in improving this document, should be addressed to

309MXSG/MXRIL, Hill AFB, UT 84056-2609 or 309MXS/MXRL@hill.af.mil. Since contact information can change, you may want to verify the currency of this address information using the ASSIST Online database at https://assist.daps.dla.mil.

ii