MIL-R-45774A (MI)
3.4.2.2 More than one type of defect. When a single production radiograph shows more than one type of defect, the following procedure shall be used in determining acceptability.
3.4.2.2.1 Governing defect. When one type of defect predominates and the other types are equal to or better than an acceptable condition for the applicable standard, the predominating defect shall govern without regard to the other types of defects present.
3.4.2.2.2 No governing defect. When two or more types of defects are present to an extent equal to the borderline condition for each type, all borderline defects shall be unacceptable and the weldment shall be rejected.
3.5 Inspection and equipment. Unless otherwise specified by the procuring agency, qualification of equipment, operators, and procedures shall be conducted in accordance with MIL-R-11470. Radiographic inspection shall be conducted in accordance with MIL-STD-453.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements (examinations and tests) as specified herein. Except as otherwise specified in the contract or purchase order, the contractor may use his own or any other facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in this specification where such inspections are deemed necessary to ensure supplies and services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items shall meet all requirements of sections 3 and 5. The inspection set forth in this specification shall become a part of the contractor's overall inspection system or quality program. The absence of any inspection requirements in the specification shall not relieve the contractor of the responsibility of ensuring that all products or supplies submitted to the government for acceptance comply with all requirements of the contract. Sampling inspection, as part of manufacturing operations, is an acceptable practice to ascertain conformance to requirements, however, this does not authorize submission of known defective material, either indicated or actual, not does it commit the Government to accept defective material.
4.2 Inspection records. The supplier shall maintain exposed radiographic negatives and written radiographic inspection records in accordance with the requirements of the procuring agency (see 6.2) for each article or unit of manufacture that has been radiographed. These exposed radiographic negatives and inspection
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business